压力过滤装置-随时可以使用

                                       READY-TO-USE PRESSURE FILTRATION UNITS

         这些压力过滤装置是为可靠无菌过滤组织方案设计的。过滤面积大、自动排气、允许高流速。连接一个泵，这些过滤器适合过滤100ml-5L介质和水相溶剂

         These pressure filtration units are designed for reliable sterile filtration of tissure solutions. They have a large filtration area and an automatic venting which allows high flow rates. Attached to a pump, these filters are suitable for the filtration of 100ml up to 5liters of media and aqueous solutions. They come in a polycarbonate hosing and have a female lure lock or hose nipple connector.

SPECIFICATION FOR SCAP

SCAP 参数

      Adsorption                        less than 10 ug per cm2 found in tests with g-Globulin

     吸附作用                         用g-球蛋白测试不小于10ug/cm2

      Bubble Point                     minimum value is 3.4bar （340KPa）

      始沸点                                       zui小值3.4bar（340KPa）

      Connectors                        入口雌鲁尔锁6-12mminlet female luer lock （6-12mm）     

          连接                                 出口加强软管接头Out stepped hose nipple （6-12mm）   

     Cytotoxicity             无毒-采用MRC- 5人胚肺细胞non-toxic as confirmed with MRC-5 embryonic lung cells      细胞毒性               and L-929 mouse fibroblast cells                和L- 929小鼠成纤维细胞确认证实

      Extractables             pass the USP plastic test class VI

      萃取物                    通过美国药典（USP）VI级塑料测试

     Filling volume           6.0ml

      灌装量                      6.0ml

     Filtration Area           20cm2

      过滤面积                  20cm2

      Flow Rates              typical flow rate for water at 250 ml/min bei △p-1bar（100kPa）

      流速                         典型流速-水--△的P -1bar（100kPa）250毫升/分钟

     Idle Volume             0.3ml after bubble point, 1.3ml before bubble point

      空闲容量                  泡点后0.3ml,泡点前1.3ml

     Materials                cellulose acetate membrane filter（0.2um）, PTFE vent. filter, polycarnate housing      

      材质                          醋酸纤维素膜过滤器（0.2um），PTFE排气过滤器，聚碳酸酯室

 Housing                Polycarbonate

 外壳                       聚碳酸酯

     Max.Pressure            max. recommended initial pressure during filtration =bar（300KPa）

过滤工作中*zui大初始压力300KPa

     zui大压力                   The hosing withstands at least 5 bar （500KPa） 室耐压至少500KPa

               北京威斯孚科技有限公司 www.wsf-tech.com;