ZP17型压片机冲模,各种形状异形冲模多品种、高品质各类压片机冲模
国际标准冲模 IPT EU International standaard P/D 普通ZP冲模 GB12253-90 Normal P/D for ZP series Press 各类电池、化工、合金冲模 P/D for battery and alloy Press 各类压片机冲模 Press oriented P/D | 25-4,ZP21,ZP11,ZPY15系列压片机冲模,各种形状异形冲模
ZP17型压片机冲模,各种形状异形冲模 |
各种进口压片机冲模,各种形状异形冲模
安 装 前 安 装 中模:用内六角扳手将位于中冲盘的中模紧固组合螺钉拧松开,用专用的工具将 下冲:打开压片机的柜门,撤出护板以 安 装 后 | Before installation Cleaning the upper、the middle and the lower of tablet machine with alcohol; cleaning stand-die with alcohol, after completed, wipe the die’s hole clean; In order to facilitate installation ,it can be coated with a small number of round cylindrical grease in the mold. Installation Upper Punch: open the window of tablet press, remove the cover, on the rail disc from a notch, manual drive cars, and put the upper punch into the hole of the upper punch vertically. When install it, you can smear a small amount of oil in the pole. Install die orderly and check whether it move smoothly or not in the hole. Remember not too tight. Middle Die: Make the fastening model portfolio screw located in the middle punch loose with the hex wrench. Install the middle die into the hole of the middle punch disc with special tools. When installation, pay more attention not to tilt relative position in the mold to ensure unnecessary damage in the holes of the middle punch disc. When screws, in order to avoid excessive damage in the middle punch disc, torque should be limited to 10N / M. Lower Punch: Open the door of tablet press; remove the protection board and the corresponding device. Put the lower punch into the hole of the lower punch vertically. Install die orderly and check whether it move smoothly or not in the hole. Remember not too tight. After installation Lifted the pressure of the main, previous roller, plate cars manually, check whether the die moves smoothly or not. Switch the machine with low speed and gradually add pressure to the requirements after confirmed normally. |